Product Description

1994-1996 Dodge Dakota, Extended Cab, Driver & Passenger, Bench Seat Belt Kit

• Driver and passenger bench positions
• Three-point retractable lap and shoulder belts
• End release buckles
• Hardware included

Both outer places on a first-generation Club Cab bench get fresh restraints from this Seatbelt Planet pair. Each one reels in when unbuckled, crosses lap and chest, and latches into an end release buckle, and the bolts come in the box.

Fitment

Built for the left and right ends of the front bench in a 1994-1996 Dakota Club Cab.

Webbing Colors

Order the pair in any of the 52 webbing colors so both sides match.

Why Replace?

Two tired belts on the same bench usually wear at the same rate, and replacing both at once keeps the cab even in look and feel.

Belt Care

Sponge both straps with a gentle soap solution and let them air dry fully extended before they rewind.

About the Dodge Dakota

The first-generation Dakota was updated several times over its run before the all-new 1997 model arrived.

Before You Install

Check both floor anchors and both upper mounts for corrosion, especially on trucks that lived in the salt belt.

Good to Know

Mounting hardware is part of the kit.

Club Cab Dakotas are recognizable by the small rear side windows behind the doors.

Trucks with the 5.2 liter Magnum V8 are a favorite with owners who tow small trailers.

Lay the old belts beside the new pair before you take anything apart.

Tug each new belt sharply after fitting to make sure both reels lock.

A three-belt kit that adds the center lap belt is listed for the same truck.

Call 574-226-6676 with any questions before ordering.

Many owners match the webbing to the original cloth, while others choose black for a clean look.

First-generation Dakota Club Cabs are now a common sight at small-truck meets, where clean interiors draw a crowd.

With two outboard bench belts in the same box, the left and right sides of the cab leave the factory, so to speak, in the same color and condition.

Owners who use their Dakota to tow a small boat or utility trailer usually ride two up, which wears both outboard belts evenly.

The pair is the most common order for this truck because the center seat is used far less than the two ends of the bench.

Seatbelt Planet's single bench belt is listed for owners who only need one side, but most people refresh both at once.

Club Cab trucks from these years had a longer cab than the regular cab and a short rear window on each side, which helps confirm what you have.

A gray or charcoal strap suits the gray cloth that many of these trucks were built with, while black works with nearly any interior.

If the front bench has been recovered, bring a swatch along when choosing the strap color so the new belts complement the fabric.

Pulling the bench forward gives you a good look at the outboard floor anchors before you order.

Rear jump seats in the Club Cab use separate belts, also offered by Seatbelt Planet.

Frequently Asked Questions

How many belts are in the kit?
Two, one for each outboard bench seat.

Is the center belt included?
No. It is sold separately, and a three-belt kit is also offered.

Retractable?
Yes, three-point retractable.

Buckle?
End release.

Hardware?
Included.

Questions about fit?
Call 574-226-6676.