Product Description

1996-1998 Toyota 4Runner Rear Driver or Passenger, Seat Belt Kit

Seatbeltplanet.com's™ 1996-2002 Toyota 4Runner, Rear Driver or Passenger Seat Belt Kit. 3 Point Retractable Lap & Shoulder Seat Belt Kit with Plastic End Release

• Retractable 3 Point Lap & Shoulder Belt
• End Release Buckle
• Rear Driver or Passenger Seating Position
• Hardware Included

The third-generation Toyota 4Runner is one of the most sought-after used SUVs on the market. Owners lift them, armor them, and drive them to places most vehicles never see, and many have well over 300,000 miles on the original engine. With that much use, the rear seat belts often get neglected. The Seatbelt Planet Toyota 4Runner Rear Driver or Passenger Seat Belt Kit replaces one rear outboard belt and is sold and shipped by Vintage Car Radio.

Check the Year Range

The product title shows 1996-1998, while the description on the page says 1996-2002 Toyota 4Runner. The third-generation 4Runner was built for the 1996 through 2002 model years. Confirm your truck's year and contact our team if you want us to double-check fitment before ordering.

Kit Description

According to the listing, this is a 3-point retractable lap and shoulder seat belt kit with a plastic end release buckle, for the rear driver or passenger seating position. Hardware is included. It covers one side, so order two for both rear outboard seats.

What Happens to Rear Belts in a 4Runner

Third-gen 4Runners are used hard, and the rear seat gets folded, tumbled, and loaded with gear. Rear belt problems are common:

• Retractors packed with trail dust that stick or fail to lock
• Webbing chafed by recovery gear, coolers, or tool bags
• Belts tucked behind folded seats for years and forgotten
• Fading from sun through the large rear glass

When you take the family or friends out on the trail, everyone in back should have a belt that works smoothly.

Webbing Colors

There are 52 webbing colors to pick from, and the specialty group (M-Stripe, the edge colors, Miami Blue, Acid Green, Bone, White and a few others) carries an upcharge listed in the picker. Black matches the factory look. Red-Edge or Orange-Edge can add some flair to a built overland rig.

Key Specs

• Vehicle: Toyota 4Runner (title: 1996-1998; description: 1996-2002)
• Position: rear driver or passenger (one belt)
• Type: 3-point retractable lap & shoulder
• Buckle: plastic end release
• Hardware: included
• SKU: 503115
• Shipping: calculated at checkout

Built for Overland Use

Plenty of third-gen 4Runners now serve as overland rigs with drawer systems, fridges, and roof racks. Even when the rear seat is often folded for cargo, the belts still matter for the days you carry passengers. A fresh retractor that locks properly is important on rough roads where sudden stops and jolts are common.

Installation

Fold or remove the rear seat as needed to reach the lower anchors and the retractor. Clean out any dirt, inspect the threads, and install the new belt with the included hardware. Route the webbing without twists and tighten securely. Test the belt by pulling it out quickly to confirm the retractor locks.

Talk to Vintage Car Radio

Want to replace the rear center belt too? Vintage Car Radio carries that as well. Contact our team with your 4Runner's year and seating setup and we will help you get everything you need in one shipment.